ELEVATE 12" FORMFLASH PLM

ELEVATE 12" FormFlash

1m x 304.8mm

Description

ELEVATE 12" FormFlash consists of a 304.8mm uncured FormFlash, factory laminated to Quickseam Tape. The strip is designed to flash inside and outside corners, pipes, penetrations, drain outlets and any other awkward details.

Preparation

The EPDM surfaces and/or mating surfaces must be dry, clean, free from dust and be prepared with ELEVATE Quickprime Plus, using a quickscrubber pad. Use of other products is not allowed. Restore the product to room temperature prior to use if exposed to temperatures below 15 degrees for prolonged periods.

Application

On cloudy days with ambient temperature below 15 degrees, the use of a heat gun is recommended to warm the Formflash and to ensure good formability. On sunny days, pre-heating of the product is usually not necessary. Apply  Quickprime Plus to all areas to receive the Formflash using a Quickscrubber pad and Handle. Allow the Quickprime Plus to completely dry before installing the Formflash, test for dryness by touching the Quickprime Plus with a clean dry finger. Remove the backing paper and carefully apply the Formflash to the pipe, corner, penetration etc.

Physical Characteristics

• Excellent moisture resistance
  
• Excellent resistance to heat and cold
• Excellent green tack

Quickprime Plus Must Be Used With This Product!